Bison Marine 2 Part
Adhesive is one of the best neoprene based contact adhesive available.
This is a 250 ml set with Part A (adhesive) and Part B (activator). It
can be used on all watersports fabrics from Hypalon? (for repairing a
RIB/ inflatable boat or a flat roof) to neoprene and trilaminate diving
suits. Also good for leather, rubber, latex, many coated fabrics and
Experienced customers have said that Bison Marine 2 part Adhesive is
technically better and more cost effective than Bostik 2402 and Evode
Mix the contents of the Part B bottle with the Part A thoroughly before
applying the glue. They are supplied in the correct proportions.
Clean the surfaces to be glued. First remove mud and grime with soap and
water. Then degrease with a solvent, depending on the substrate you can
use, Isopropl alcohol, Methyl Ethyl Ketone, Acetone or Toluene. Do NOT
use White Spirit or Turpentine. You can lightly sandpaper the surface to
provide a good "key" for the glue. Apply a think layer of glue to each
surface to be bonded. Allow the glue to become touch dry. Apply a second
layer on top, and allow to become touch dry. Carefully position the
parts and then firmly press them together. Apply strong pressure over
every part of the bonded surface. The bond will develop full strength
after 24 hours, however 85% of bond strength is achieved after 1 hour.